The Hurricane Clip provides a connection between the truss or rafter and the wall of the structure that helps resist wind and seismic forces. The Hurricane Clip is designed for nominal 2x lumber. These U-shaped hurricane ties provide faster installation than using two single-sided ties. The embossments add stiffness in crucial areas for improved performance.
Key Features
Holds the rafter or truss on both sides for high lateral load resistance
Can be installed on inside or outside of wall, or both sides
Can be installed with flanges facing either inward or outward
Provides faster installation than using two single-sided ties
Material
1.2mm galvanized steel G300 Z275
Installation
Use all specified fasteners; see General Notes.
Hurricane ties do not replace solid blocking.
When installing ties on plated trusses (on the side opposite the truss plate) do not fasten through the truss plate from behind. This can force the truss plate off of the truss and compromise truss performance.
Hurricane Clips for Roof
| Material |
G300 Z275 Galvanised Steel |
| Size |
135mm x 135mm |
| Key words |
| hurricane clip,hurricane clips for roof |
|
Package
Our hurricane clips for roof will be packed in the cartons.
Your message must be between 20-3,000 characters!